Water Heater Pilot Light Keeps Going Out Honeywell Valve

Water Heater Pilot Light Keeps Going Out Honeywell Valve

WARNING:
DO NOT SET VALVE TO A,B,C, or VERY HOT!
Honeywell Valve has detected a“water too hot” event, the gas valve will never work again — unless you know how to reset “it”, the HONEYWELL FRANKENVALVE! Here is the simple fix. I opened the cover again, left everything plugged in, took a piece of speaker wire with the plastic off of the ends, and held the wire ends to the top left pin and the top right pin for a few seconds. I saw that the light went out and the pilot had gone out. I closed the cover again and lit the pilot again. Now the light changed from flashing 4 times to flashing 7 times. This time I left the knob in the pilot position for 10 minutes. When I came back to check the water heater, I saw that the light was flashing normally. I turned the knob to just the Hot setting and it fired up! MY CHOICE / NOW, WHAT’S YOURS? Please Subscribe, Like and Share my Videos.

Links : http://www.tylertork.com/qna/2013/gasvalve





[HPGE]